Make sure you have read the 1.9.1 and 1.9.2 topics before poceed.
To finalize the Format Change for the S700-SP machine you must to follow the following steps:
- insert the value of the mold heigth
- remove old mold removing the two M8 screws
- if the new mold needs a different attaching plate, replace the previous one with the new one
- put on the new mold
- put the machine in the automatic mode and make the ripositioning using the blinking red button
- put the machine in the manual mode and trim the upper guide to the righth heigth according to the box that you want to produce
- sent a sheet from the S700-GL and stops the conveyour when the sheet reaches the S700-SP
- using the two arrow on the operator pannel on the automatic mode of the S700-SP, move the machine until the length photocell stays between 7 and 10mm far form the paper