The steps to be run on the S700 line to start the automatic production of coated boxes are :
- Verify that any supply is working and in good condition: those are, electric, water and air supply; LAN connection is essential too for a good functioning machine;
- Arm the door lock switches on each the pointer system S700-SP, the wrapper S700-WP and the quadstayer S700-QS control panel;
- Inspect every machine to assure a correct functioning and perfect efficiency;
- Verify that every protection has been locked;
- Check the armature status of all emergency buttons;
- Start the gluer S700-GL;
- Wait untill the glue inside the gluer S700-GL has reached the desired features;
- Check that the all line has been provided with the right equipment corresponding the selected format;
- Supply with proper and enough paper the gluer S700-GL and cardboard for the quadstayer S700-QS;
- Start the quadstayer S700-QS untill the supply belt for the pointing system S700-SP is fully charged with boxes;
- Set each machine to Auto and, when necessary, reset by pressing the enabled button on the multifunction keyboard;
- Start each machine by pressing the enabled button on the multifunctioning keybord;
- Start the conveyor belt using the enabled button on the multifunctioning keybord on the gluer S700-GL;
- Start the paper sheets processing using the enabled button on the multifunctioning keybord on the gluer S700-GL;
The Auto mode of the S700 line can be stopped in three different ways:
- Last cycle stop : exiting from the automatic mode of any machine or disabling the conveyor belt (S700-GL), the S700 Line ends the production of the last box and stops waiting for the Auto Mode Restore;
- Work interruption : by disconnecting the line from one of the door lock switches located on the panel or directly from the general supply breaker, the line immediately stops its functions;
- End work stop : disarming the paper sheets exit of the gluer (S700-GL), te S700 line starts its stop procedure emptying the conveyor belt. It will end the production of each piece started without introducing new ones into production;
-
Emergency stop : in the event of imminent danger or mechanical problem the line can be stopped by pressing one of the four emergency buttons on the machine. This will instantly stop all the operation of the line and it won't start up until the button is pressed again.
To exit the emergency situation, you also need to press the reset button enabled in the multifunction keyboard and repeat the startup procedures in Auto mode or change the size depending on the task to be performed.
CAUTION
The last cycle stoppage compromises the quality of the products awaiting on the conveyor belt due to a progressive deterioration of the glue waiting.
We do not recommend using this method except for very short stops.
CAUTION
As with the last cycle stop, the usual considerations apply to work interruption, but in addition, if the power supply is switched off by pressing the button on the pointing system S700-SP or the general-purpose supply breaker, then a manual roller wash must be provided for the gluer S700-GL before resuming work.
CAUTION
During the emergency stop any electric controller is still activated.
CAUTION
Use emergency stop only when it's really needed.
Inthe case described above all the warnings of the previous cases apply.